(16) Set the MNT Check Gauge as shown below. (15) Rotate the gear of the CL Drive Cam with your finger to raise the Print Head Caps. (14) Move the W Rack Gear Unit to the rearmost position with your finger. (13) Rotate the gear of the CL Drive Cam with your finger to move the Print Head Caps to the lower position. Use the provided MNT Check Gauge shown below for the adjustment. (12) Lightly fasten the four bolts (in the red circles shown below) in the front and rear so that the Maintenance Unit can be moved back and forth.Īdjusting the lengthwise position of the Maintenance Unit (11) Insert the Maintenance Unit from the rear of the Main Unit, and then align the two U-shaped grooves in the front and rear of the Maintenance Unit to the Main Unit Frame positioning pins. (10) Pull out the Maintenance Unit to the rear. (9) Remove the four bolts (in the red circles shown below) in the front and rear of the Maintenance Unit. (8) Disconnect the Drain Tube from the Fitting. (7) Disconnect the connectors on the PCB in the rear of the Maintenance Unit. Removing the Maintenance Unit from the Main Unit (5) Turn off GT-541, and then unplug the power cord. The message "Turn Off & Please Clean Cap & Wiper" appears. (The Platen moves to its storage position, The Cap mechanism of the Maintenance Unit falls off the Print Head Nozzle, and the Carriage moves to the center position and then stops.)
(4) Press the Up/Down Button to select "Cap/Wiper Clean", and then press the OK Button. (3) Press the Up/Down Button to select "Maintenance", and then press the OK Button. (2) Press the OK Button on the Control Panel to open the Menu Display. (1) Make sure GT-541 is not in the middle of any operation. Replacing Maintenance PCB" when you replace Maintenance PCB.