The Arc OK light does not light up when using the unit. The Masso is getting the up/down/Ark ok signals when I run test. Quote from Buckmaster1967 on March 6, 2020, 12:47 pmĭid you wire it as per Price instructions with 5.6K resistors Masso's input or wire it similar to the Proma guide here? Quote from SegoMan DeSigns on March 10, 2020, 4:08 pm The same Gcode that works for the Proma 15o will work for the Price AVHC10. Once these connections are working it is a matter of the right Gcode and settings in the THC. As you cycle through the THC outputs using the Jog wheel on the THC you should see the corresponding input on Masso change. The first thing to test is to put the THC into output signal test mode and look at the F1 screen to make sure that the Arc ok, Up & Down inputs on Masso change from a normal state of Low to High. It should be wired the same as The Proma 150 using resistors on each of the inputs and the THC switching ground. It would be nice to answer this question once and for all as well as get you up and running. Quite often users ask if the price works and I can personally see no reason why it won't. Good one, I'll keep an eye out for posts from you. Quote from MASSO Support on March 6, 2020, 9:47 pm Then it is slow working, and not dependable enough to trust. If I remember right, the controller will work, but I have to set the voltage way lower than the Hypertherm book calls for. I will have to give it another shoot this week end. And you are right, it should be childs play like on other systems. I am using Sheetcam with the Masso Plasma post processor. The last time post you had post processor issues and were using the Price post processor designed for an unknown controller instead of the Masso Plasma post processor. If you want to have another try i'm happy to help out.Ĭheers to hear that. You want Plasma POST Processor with THC at the bottom.įrom what I can tell The Price should work with Masso without a problem and should be childs play to set up.
#SHEETCAM PRICE DOWNLOAD#
Did you download the Masso post processor and try it? Sheetcam Plasma Post Processor for Masso It looks like you are using Sheetcam from the post processor. Quote from MASSO Support on March 6, 2020, 3:54 to hear that.
I realize my knowledge of the subject is weak, but it just should not be this complicated. I really like the Masso quick start, but the easy setup of my coworker system has me thinking. Truth, it got me thinking of switching over. My coworker has the Price unit on his homemade table with Mach4. My table cuts great on all thickness without a Height Controller. Truth is, I all but have given up on Masso with the Price unit. Hello, I so wish I could tell you I got it working and was a happy cutter. Quote from Buckmaster1967 on March 6, 2020, 1:23 am